Ford Model 68 T10 Shifters and Control Modules

Old trucks are just meant to have manual transmissions. They're made even better with a modern overdrive like a Tremec TKX. Watch our C10 manual transmission conversion on an LS-swapped '68 to see just how easy it is to row your own gears,

In this Tech Tip, John responds to a customer question about tubular control arms.

In Episode 3 of our C10 build, we install a front suspension kit and finally have a rolling chassis!

In this episode of our C10 build series, we swap cams in a junkyard 5.3 and make surprisingly big power.

In Episode 2 of our '68 C10 build, we rip it apart, clean up 54 years of rust and dirt, and get to work on the rear suspension.

It's alive! Our 1968 C10 truck project is one step closer to our first drive. In this episode, our old truck finally comes to life with a cammed junkyard LS.

In this episode of our '68 C10 project, we hit a couple big milestones. The engine goes in and we hit our first car show. It may be just a rolling chassis, but we're mighty proud of how far we've come.

Looking to update that '67-'72 C10 truck with an LS swap? These motors mounts and transmission crossmember kit will make that modern powerplant and transmission fit like they came that way from the factory!

Here's how we got rid of the gas tank behind the seat using one of our 67-72 C10 under bed fuel tanks and completed the C10 LS swap fuel system in our '68 C10 project.

In this Tech Tip, John answers a customer question about what would be needed to swap some additional power in place of his anemic 233c.i. Ford.