Chevy DP C6 Driveline and Axles

In this Tech Tip, John answers a customer question about finding the right axle length for his 1931 Model A.

In this tech article, we show you how to measure the working angles on your drive shaft to ensure long life out of your U-joints.

With the coil-overs attached, it is now time to make the Chevelle rear whole again. Follow along as Jeff installs a 9" third member and spline axles with a few tips on axle lengths and bolt patterns.

Learn the installation process of a drive shaft loop kit in a 1967 Chevelle. NHRA requires a driveshaft loop if you're going to run slicks on the drag strip!

Axle / Clevis / Bracket / Radius Rod Assembly

Looking for a driveshaft for your 67-72 C10? Our custom-length driveshaft kits make it a breeze to get the perfect 67-72 C10 driveshaft length. Follow along as we show how to measure and install a C10 one piece driveshaft.

Jeff preps the rear end housing to secure the brake lines and shows how to fasten bolt-on brake line tabs on the lower trailing arm bracket. Follow along as he applies Wilwood Dynalite Calipers to his 1967 Chevelle.

In this article, Jeff provides tips on how to successfully install a custom length driveshaft into his 1967 Chevelle. This guide explains how to take accurate measurements while choosing your specific length, slip yoke, and u-joints for a perfect fit.

Drag racing changed a lot in the 60's, and Dick Landy was right in the middle of it all. This 64 Dodge was the first factory built 426 Hemi car to win a sanctioned drag race. How cool is that?

Dan's Chevelle started out as a Christmas present in 1993. It's been with him ever since, for better and for worse. Here's the story in Dan's words.