Chevy Chevelle Multi Purpose Retainers

Get more details on Project Chevelle's 9-inch housing, third member, and tubular control arms installation.

Jeff's Chevelle gets a dash overhaul. Follow along as he assembles the dash components and installs the A/C evaporator unit. This project highlights a refinished dash top, Astro vents and a new padded dash bumper.

See how Jeff installs Hedman mid-length headers to the big block in his '67 Chevelle. Learn about the modifications made to the steering shaft and the clamp on the lower steering column for a successful application.

Jeff demonstrates how to install the front runner drive system by Vintage Air in his 1967 Chevelle project car all while maintaining a simple, factory fresh look.

With the coil-overs attached, it is now time to make the Chevelle rear whole again. Follow along as Jeff installs a 9" third member and spline axles with a few tips on axle lengths and bolt patterns.

Jeff demonstrates how to install a high quality rear trailing arm kit for his 1967 Chevelle. Learn more about the a-body rear suspension and its unique set of requirements. Find out how to eliminate wheel hop and promote “forward bite”.

In this Tech Tip, John offers some suggestions about lowering a 1967 Chevelle.

This article highlights the finishing touches of the front suspension in Jeff's Chevelle. Learn some tips on how to install the steering arms, center link and tie rod assembly.

Next up is the suspension on Jeff's 1967 Chevelle project. Learn how to properly disassemble and remove components, such as the spindles and brakes. See tips on replacing the control arm bushings and using the right tools to get the job done.

Jeff chooses Redline Radial Tires and black powder-coated steel wheels for his 1967 Chevelle. See how he installs the tires with some helpful tips along the way.