Chevy Chevelle Auto Meter Mounting Solutions

Get more details on Project Chevelle's 9-inch housing, third member, and tubular control arms installation.

Follow this guide on how to mount a single electric puller fan in a '66 - '67 Chevelle. Learn tips on taking measurements and installing a rubber spacer to prevent the fan from rubbing.

Kevin W. walks through each step of installing a new alternator bracket on a 454 Big Block Chevy.

Jeff demonstrates how to install and mount an A/C evaporator in his 1967 Chevelle. Read some tips on how to get a clean factory appearance.

Follow this step by step guide on how to install adjustable LS motor mounts to set your engine location exactly where you want it.

Jeff preps the rear end housing to secure the brake lines and shows how to fasten bolt-on brake line tabs on the lower trailing arm bracket. Follow along as he applies Wilwood Dynalite Calipers to his 1967 Chevelle.

Learn how to equip your car with A/C by installing the Vintage Air GenIV SureFit Complete Kit. Jeff installs this kit in his 1967 Chevelle while making some vent modifications to enhance the look and direct air better.

In this Tech Tip, John offers some suggestions about lowering a 1967 Chevelle.

Follow along as Jeff installs an early 700R4 transmission for the big block in his 1967 Chevelle. See how this unit is upgraded and converted to a later 30 spline style.

With the coil-overs attached, it is now time to make the Chevelle rear whole again. Follow along as Jeff installs a 9" third member and spline axles with a few tips on axle lengths and bolt patterns.