Chevy 3E C6 Driveline and Axles

Get more details on Project Chevelle's 9-inch housing, third member, and tubular control arms installation.

In this Tech Tip, John answers a customer question about finding the right axle length for his 1931 Model A.

With the coil-overs attached, it is now time to make the Chevelle rear whole again. Follow along as Jeff installs a 9" third member and spline axles with a few tips on axle lengths and bolt patterns.

Axle / Clevis / Bracket / Radius Rod Assembly

In this tech article, we show you how to measure the working angles on your drive shaft to ensure long life out of your U-joints.

Project Chevelle gets new wheels and tires, and a massive personality change! Watch as we add a huge dose of visual horsepower to the old Chevelle.

In Episode 3 of our C10 build, we install a front suspension kit and finally have a rolling chassis!

Learn the installation process of a drive shaft loop kit in a 1967 Chevelle. NHRA requires a driveshaft loop if you're going to run slicks on the drag strip!

Looking for a driveshaft for your 67-72 C10? Our custom-length driveshaft kits make it a breeze to get the perfect 67-72 C10 driveshaft length. Follow along as we show how to measure and install a C10 one piece driveshaft.

Jeff preps the rear end housing to secure the brake lines and shows how to fasten bolt-on brake line tabs on the lower trailing arm bracket. Follow along as he applies Wilwood Dynalite Calipers to his 1967 Chevelle.