Cadillac DeVille Line Clamps

Exhaust clamps are the perfect DIY solution to assembling your performance exhaust system at home, but what is the best clamp to use for your application. Find out in our buyer’s guide.

Next up, Jeff replaces the brake lines on his Chevelle. See how he uses a double flaring brake line tool by Titan Tools to create double flares. This tool is sure to make your life easier, and save some time!

Jeff preps the rear end housing to secure the brake lines and shows how to fasten bolt-on brake line tabs on the lower trailing arm bracket. Follow along as he applies Wilwood Dynalite Calipers to his 1967 Chevelle.

Learn how to install a Line lock as well as installing a line lock button and how a line lock works, with Kevin as he goes through the process on his '54 Chevy Belair.

Jeff demonstrates how to plumb the brake master cylinder with steel lines in his 1967 Chevelle. See tips on how to bend brake lines, use flare tools to make double flares, and give hard lines some spring.

Learn how to repair an oil line leak using steel braided hose and AN fittings. See how to cut the hose, measure angles, apply fittings and install fuel lines back into your car.

Learn how to assemble a Gotta Show transmission cooler line kit for common GM transmissions. Jeff shares some helpful tips on measuring and cutting the braided stainless steel hose for an easier installation.

Plumbing a fluid system can sometimes be frustrating. In this article, Steve walks you through a brake line installation with pro tips to get the job done right.

Tim talks about our new Brookville Model A steel deck lid.

Learn the installation process of a drive shaft loop kit in a 1967 Chevelle. NHRA requires a driveshaft loop if you're going to run slicks on the drag strip!