1978 Chevy C20 Driveline and Axles

In this Tech Tip, John answers a customer question about finding the right axle length for his 1931 Model A.

Over several generations of small block Chevy (and big block Chevy) engines there have been several changes that dictate what flexplate works with them. We’ll help you determine the correct flexplate for your Chevy engine in this buyer’s guide.

In this tech article, we show you how to measure the working angles on your drive shaft to ensure long life out of your U-joints.

With the coil-overs attached, it is now time to make the Chevelle rear whole again. Follow along as Jeff installs a 9" third member and spline axles with a few tips on axle lengths and bolt patterns.

Looking for a driveshaft for your 67-72 C10? Our custom-length driveshaft kits make it a breeze to get the perfect 67-72 C10 driveshaft length. Follow along as we show how to measure and install a C10 one piece driveshaft.

Now that our '68 C10 cab is straight and rust-free, it's time to bolt on the rest of the sheet metal, get it straight, and get it painted!

From a mild leveling to slammed and “in the weeds” there are several options to lowering a C10. We discuss the options in our ’67-’72 C10 lowering guide.

In Episode 3 of our C10 build, we install a front suspension kit and finally have a rolling chassis!

Jason Ankerson's 1965 Chevy C10 began its life as his high school beater. Over a decade of transformations, his first-gen C10 has become a modern reliable cruiser.

Chris Ryan's '78 Firebird is a loving tribute to that famous Trans Am from _Smokey & the Bandit_, but with style and performance that would have been nearly impossible when the Bandit was busy with Sheriff Justice.