1969 Chevy G10 Van Pontiac V8 Ignition, Charging and Starting Parts

GM’s 10-bolt rear axle has been around since the 1960s, here’s how to determine if your junkyard find is worth taking home

It's alive! Our 1968 C10 truck project is one step closer to our first drive. In this episode, our old truck finally comes to life with a cammed junkyard LS.

Learn about the wiring of GM HEI Ignition Distributors with our diagrams and guide. Ensure you are getting the best performance out of your ignition system.

In Episode 2 of our '68 C10 build, we rip it apart, clean up 54 years of rust and dirt, and get to work on the rear suspension.

To keep this project moving forward, Jeff installs a gear reduction mini starter on his big block. See how to apply the mini starter on 153 or 168 tooth flexplates.

Read up on GM 10 bolt ring and pinion installation instructions. Follow along as our employee Zach installs a GM 10 bolt rebuild kit from Motive Gear.

It's done! Well, at least for now. Check out the conclusion of our 1968 C10 pickup truck build!

Bringing an old Mopar back to life isn't always a breeze. Fortunately, MSD has come up with a solution for those outdated and unreliable points-type ignition systems. Find out how to install a MSD 8386 distributor and MSD 5531 spark plug wires

In this episode of our C10 build series, we swap cams in a junkyard 5.3 and make surprisingly big power.

Speedway Tech Zach discusses the Pertronix Ignitor III conversion in his '55 Chevy.