Powermaster 1968 Jeep J-100 Parts

It's alive! Our 1968 C10 truck project is one step closer to our first drive. In this episode, our old truck finally comes to life with a cammed junkyard LS.

It's done! Well, at least for now. Check out the conclusion of our 1968 C10 pickup truck build!

We've come a long way on our '68 C10 project, but we still have a long way to go. Watch as Kevin and Joe discuss where we're at and where we're going.

In this Tech Tip, John responds to a customer request for our recommendations on brake kits for his ’56 F100.

In Episode 3 of our C10 build, we install a front suspension kit and finally have a rolling chassis!

In this Tech Tip, John answers a customer question about what would be needed to swap some additional power in place of his anemic 233c.i. Ford.

In this episode of our '68 C10 project, we hit a couple big milestones. The engine goes in and we hit our first car show. It may be just a rolling chassis, but we're mighty proud of how far we've come.

Our project '68 C10 had some pretty rough sheet metal. In this episode, we go from a scary, rusty mess to a complete cab ready for bodywork.

In this episode of our C10 build series, we swap cams in a junkyard 5.3 and make surprisingly big power.

In Episode 2 of our '68 C10 build, we rip it apart, clean up 54 years of rust and dirt, and get to work on the rear suspension.