1968 Ford E-200 Econoline FMX Engine Parts

It's alive! Our 1968 C10 truck project is one step closer to our first drive. In this episode, our old truck finally comes to life with a cammed junkyard LS.

In this episode of our '68 C10 project, we hit a couple big milestones. The engine goes in and we hit our first car show. It may be just a rolling chassis, but we're mighty proud of how far we've come.

In this episode of our C10 build series, we swap cams in a junkyard 5.3 and make surprisingly big power.

In Episode 2 of our '68 C10 build, we rip it apart, clean up 54 years of rust and dirt, and get to work on the rear suspension.

In Episode 3 of our C10 build, we install a front suspension kit and finally have a rolling chassis!

We've come a long way on our '68 C10 project, but we still have a long way to go. Watch as Kevin and Joe discuss where we're at and where we're going.

Follow this restoration guide as Josh breathes new life back into his Pontiac engine.

Jeff walks through how to install an EFI filter for his fuel system. See how to assemble conversion fittings to accurately plumb the fuel lines and tips on fuel line routing.

Jeff demonstrates how to install the front runner drive system by Vintage Air in his 1967 Chevelle project car all while maintaining a simple, factory fresh look.

A step by step on how to install an EFI Fuel Tank kit in a 1967 Chevelle. Learn the benefits of using this kit including expanded fuel capacity and a 24 gallon tank.