1968 Chevy K10 C6 Interior, Accessories and Trim Parts

Like many, we found ourselves with a rusty C10 project. Watch as we show how to tackle common 67-72 C10 rust repair, including floor pan replacement, rocker panel replacement, and cab corner repair.

It's alive! Our 1968 C10 truck project is one step closer to our first drive. In this episode, our old truck finally comes to life with a cammed junkyard LS.

Now that our '68 C10 cab is straight and rust-free, it's time to bolt on the rest of the sheet metal, get it straight, and get it painted!

It's done! Well, at least for now. Check out the conclusion of our 1968 C10 pickup truck build!

In this episode of our C10 build series, we swap cams in a junkyard 5.3 and make surprisingly big power.

In Episode 3 of our C10 build, we install a front suspension kit and finally have a rolling chassis!

In this episode of our '68 C10 project, we hit a couple big milestones. The engine goes in and we hit our first car show. It may be just a rolling chassis, but we're mighty proud of how far we've come.

In Episode 2 of our '68 C10 build, we rip it apart, clean up 54 years of rust and dirt, and get to work on the rear suspension.

When Tyson picked up his '69 SS396, all the trim was in the trunk. We follow along as he installs the shiny stuff to finish out his project.

Our project '68 C10 had some pretty rough sheet metal. In this episode, we go from a scary, rusty mess to a complete cab ready for bodywork.