1968 Chevy C20 Suburban Parts

Now that our '68 C10 cab is straight and rust-free, it's time to bolt on the rest of the sheet metal, get it straight, and get it painted!

In Episode 3 of our C10 build, we install a front suspension kit and finally have a rolling chassis!

In this episode of our C10 build series, we swap cams in a junkyard 5.3 and make surprisingly big power.

Our project '68 C10 had some pretty rough sheet metal. In this episode, we go from a scary, rusty mess to a complete cab ready for bodywork.

It's alive! Our 1968 C10 truck project is one step closer to our first drive. In this episode, our old truck finally comes to life with a cammed junkyard LS.

We've come a long way on our '68 C10 project, but we still have a long way to go. Watch as Kevin and Joe discuss where we're at and where we're going.

Jason Ankerson's 1965 Chevy C10 began its life as his high school beater. Over a decade of transformations, his first-gen C10 has become a modern reliable cruiser.

Not only is Greg Turner's '56 a great driver, it's full of great family memories. Built in the home garage by Greg and his sons, this clean Chevy has covered a lot of miles.

In Episode 2 of our '68 C10 build, we rip it apart, clean up 54 years of rust and dirt, and get to work on the rear suspension.

In this episode of our '68 C10 project, we hit a couple big milestones. The engine goes in and we hit our first car show. It may be just a rolling chassis, but we're mighty proud of how far we've come.