1967 Chevy G20 Van AMC Inline 6 Engine Parts

Jeff demonstrates how to install the front runner drive system by Vintage Air in his 1967 Chevelle project car all while maintaining a simple, factory fresh look.

Next up is the suspension on Jeff's 1967 Chevelle project. Learn how to properly disassemble and remove components, such as the spindles and brakes. See tips on replacing the control arm bushings and using the right tools to get the job done.

Learn about the G Force crossmember and how the symmetrical product design makes for a smooth installation on Jeff's 1967 Chevelle.

Learn how to assemble a Gotta Show transmission cooler line kit for common GM transmissions. Jeff shares some helpful tips on measuring and cutting the braided stainless steel hose for an easier installation.

Learn how to equip your car with A/C by installing the Vintage Air GenIV SureFit Complete Kit. Jeff installs this kit in his 1967 Chevelle while making some vent modifications to enhance the look and direct air better.

With the coil-overs attached, it is now time to make the Chevelle rear whole again. Follow along as Jeff installs a 9" third member and spline axles with a few tips on axle lengths and bolt patterns.

This article highlights the finishing touches of the front suspension in Jeff's Chevelle. Learn some tips on how to install the steering arms, center link and tie rod assembly.

A step by step on how to install an EFI Fuel Tank kit in a 1967 Chevelle. Learn the benefits of using this kit including expanded fuel capacity and a 24 gallon tank.

Jeff demonstrates how to plumb the brake master cylinder with steel lines in his 1967 Chevelle. See tips on how to bend brake lines, use flare tools to make double flares, and give hard lines some spring.

Jeff preps the rear end housing to secure the brake lines and shows how to fasten bolt-on brake line tabs on the lower trailing arm bracket. Follow along as he applies Wilwood Dynalite Calipers to his 1967 Chevelle.