1967 Chevy G10 Van Brakes

Old trucks are just meant to have manual transmissions. They're made even better with a modern overdrive like a Tremec TKX. Watch our C10 manual transmission conversion on an LS-swapped '68 to see just how easy it is to row your own gears,

Jeff preps the rear end housing to secure the brake lines and shows how to fasten bolt-on brake line tabs on the lower trailing arm bracket. Follow along as he applies Wilwood Dynalite Calipers to his 1967 Chevelle.

Jeff demonstrates the installation of front brake lines and hoses for his 1967 Chevelle. Learn how he uses a Titan mini-bender for all the tight bends this job required and an important tip on sealing pipe threads.

Jeff demonstrates how to plumb the brake master cylinder with steel lines in his 1967 Chevelle. See tips on how to bend brake lines, use flare tools to make double flares, and give hard lines some spring.

Jeff installs a Wilwood 12.19" Front Disc Brake Kit to his 1967 Chevelle. Read more on the caliper bracket assembly and brake rotor setup.

From a mild leveling to slammed and “in the weeds” there are several options to lowering a C10. We discuss the options in our ’67-’72 C10 lowering guide.

A guide on how to install Wilwood rear brakes for performance and better handling suspension. Learn about critical clearance for the outer axle components on Jeff's 1967 Chevelle.

Jeff converts his 1967 Chevelle manual brake system to power by installing a Delco booster kit. Learn how to make the master cylinder more resistant to brake fluid and a few tips for an easy install.

Next up, Jeff replaces the brake lines on his Chevelle. See how he uses a double flaring brake line tool by Titan Tools to create double flares. This tool is sure to make your life easier, and save some time!

In Episode 3 of our C10 build, we install a front suspension kit and finally have a rolling chassis!