1966 Studebaker Commander AMC V8 Engine Parts

To celebrate the upcoming 106th running of the Indianaplis 500, here's a look back at a few of the engines that have competed at the Brickyard over the years.

Heath P. tells his story on how the passion for 'hot rodding' was instilled in him by his grandfather. From driving tractors on their family farm to becoming a Ford family, you are in for a good read.

It's alive! Our 1968 C10 truck project is one step closer to our first drive. In this episode, our old truck finally comes to life with a cammed junkyard LS.

In this episode of our '68 C10 project, we hit a couple big milestones. The engine goes in and we hit our first car show. It may be just a rolling chassis, but we're mighty proud of how far we've come.

Blown 1966 Chevy C10 built for cruising.

We've come a long way on our '68 C10 project, but we still have a long way to go. Watch as Kevin and Joe discuss where we're at and where we're going.

It's done! Well, at least for now. Check out the conclusion of our 1968 C10 pickup truck build!

Next up is the suspension on Jeff's 1967 Chevelle project. Learn how to properly disassemble and remove components, such as the spindles and brakes. See tips on replacing the control arm bushings and using the right tools to get the job done.

Our project '68 C10 had some pretty rough sheet metal. In this episode, we go from a scary, rusty mess to a complete cab ready for bodywork.

In Episode 3 of our C10 build, we install a front suspension kit and finally have a rolling chassis!