Classic Auto Locks 1966 Chevy Chevelle Parts

Sometimes, a simple paint job can cause a project to spiral out of control. In the case of Steve's '66 Chevelle, it came out way better than anyone expected.

In this Tech Tip, John offers some suggestions about lowering a 1967 Chevelle.

Learn how to equip your car with A/C by installing the Vintage Air GenIV SureFit Complete Kit. Jeff installs this kit in his 1967 Chevelle while making some vent modifications to enhance the look and direct air better.

This article highlights the finishing touches of the front suspension in Jeff's Chevelle. Learn some tips on how to install the steering arms, center link and tie rod assembly.

Learn the installation process of a drive shaft loop kit in a 1967 Chevelle. NHRA requires a driveshaft loop if you're going to run slicks on the drag strip!

Jeff installs a Wilwood 12.19" Front Disc Brake Kit to his 1967 Chevelle. Read more on the caliper bracket assembly and brake rotor setup.

Jeff tackles the installation of the Lokar Muscle Car Shifter inside of a factory stick-shift floor pan section. This product won a "Best Interior Product" Award at the SEMA show in 2016.

Next up is the suspension on Jeff's 1967 Chevelle project. Learn how to properly disassemble and remove components, such as the spindles and brakes. See tips on replacing the control arm bushings and using the right tools to get the job done.

With the coil-overs attached, it is now time to make the Chevelle rear whole again. Follow along as Jeff installs a 9" third member and spline axles with a few tips on axle lengths and bolt patterns.

With the new housing and brakes installed, Jeff chooses new wheels and tires for his 1967 Chevelle. See how he gets the perfect fit with enough clearance for brakes, coilovers and even 15" wheels.