1966 Chevy Caprice Bert Driveline and Axles

With the coil-overs attached, it is now time to make the Chevelle rear whole again. Follow along as Jeff installs a 9" third member and spline axles with a few tips on axle lengths and bolt patterns.

In this article, Jeff provides tips on how to successfully install a custom length driveshaft into his 1967 Chevelle. This guide explains how to take accurate measurements while choosing your specific length, slip yoke, and u-joints for a perfect fit.

Learn the installation process of a drive shaft loop kit in a 1967 Chevelle. NHRA requires a driveshaft loop if you're going to run slicks on the drag strip!

Sometimes, a simple paint job can cause a project to spiral out of control. In the case of Steve's '66 Chevelle, it came out way better than anyone expected.

Jeff preps the rear end housing to secure the brake lines and shows how to fasten bolt-on brake line tabs on the lower trailing arm bracket. Follow along as he applies Wilwood Dynalite Calipers to his 1967 Chevelle.

Follow this guide on how to install a splined sway bar for GM A-body applications. See the installation process on a '68 Chevelle frame using stock control arms and factory chassis bolt and pad locations.

Follow along as Jeff chooses redline radial tires and steel wheels to get the perfect fit for his Chevelle. Learn how redlines are added to a set of Real Rodder mags for a consistent 60's theme.

Jeff chooses Redline Radial Tires and black powder-coated steel wheels for his 1967 Chevelle. See how he installs the tires with some helpful tips along the way.

Jeff demonstrates how to plumb the brake master cylinder with steel lines in his 1967 Chevelle. See tips on how to bend brake lines, use flare tools to make double flares, and give hard lines some spring.

Learn how to equip your car with A/C by installing the Vintage Air GenIV SureFit Complete Kit. Jeff installs this kit in his 1967 Chevelle while making some vent modifications to enhance the look and direct air better.