1966 Chevy C20 E40D Driveline and Axles

With the coil-overs attached, it is now time to make the Chevelle rear whole again. Follow along as Jeff installs a 9" third member and spline axles with a few tips on axle lengths and bolt patterns.

After installing front brakes, Jeff is now ready for wheels and tires. See how a spacer is used to make his 15" wheels fit just right and a slick way to speed up the sanding and polishing process of the wheel dust caps.

Learn the installation process of a drive shaft loop kit in a 1967 Chevelle. NHRA requires a driveshaft loop if you're going to run slicks on the drag strip!

In this article, Jeff provides tips on how to successfully install a custom length driveshaft into his 1967 Chevelle. This guide explains how to take accurate measurements while choosing your specific length, slip yoke, and u-joints for a perfect fit.

Sometimes, a simple paint job can cause a project to spiral out of control. In the case of Steve's '66 Chevelle, it came out way better than anyone expected.

Follow this guide on how to install a splined sway bar for GM A-body applications. See the installation process on a '68 Chevelle frame using stock control arms and factory chassis bolt and pad locations.

Jeff preps the rear end housing to secure the brake lines and shows how to fasten bolt-on brake line tabs on the lower trailing arm bracket. Follow along as he applies Wilwood Dynalite Calipers to his 1967 Chevelle.

With the new housing and brakes installed, Jeff chooses new wheels and tires for his 1967 Chevelle. See how he gets the perfect fit with enough clearance for brakes, coilovers and even 15" wheels.

Jason Ankerson's 1965 Chevy C10 began its life as his high school beater. Over a decade of transformations, his first-gen C10 has become a modern reliable cruiser.

Jeff demonstrates how to plumb the brake master cylinder with steel lines in his 1967 Chevelle. See tips on how to bend brake lines, use flare tools to make double flares, and give hard lines some spring.