Competition Engineering 1965 Ford LTD Parts

Speedway Motors employee Alanna C. walks through the how-to of installing the Vintage Air A/C in her 1965 Ford Mustang.

Street Rod Tech Steve L. talks about the need to be able to service and adjust the shocks on your vehicle, no matter the competition you built it for.

Speedway Motors employee Alanna C. talks about the process of tearing down her 1965 Ford Mustang to make room for the Vintage Air A/C kit.

In this episode of our '68 C10 project, we hit a couple big milestones. The engine goes in and we hit our first car show. It may be just a rolling chassis, but we're mighty proud of how far we've come.

Follow this restoration guide as Josh breathes new life back into his Pontiac engine.

Derek kicks off his 55 Chevy rebuild with a fresh small block.

Jeff demonstrates how to install the front runner drive system by Vintage Air in his 1967 Chevelle project car all while maintaining a simple, factory fresh look.

In Episode 3 of our C10 build, we install a front suspension kit and finally have a rolling chassis!

In Episode 2 of our '68 C10 build, we rip it apart, clean up 54 years of rust and dirt, and get to work on the rear suspension.

We will show you the differences among traditional I-beam and tube axles and suspension designs used on hot rods; the differences between cross and traditional steering, measuring for springs, what spindles to choose, and much more.