1965 Ford Custom Accessory Drive

Speedway Motors employee Alanna C. talks about the process of tearing down her 1965 Ford Mustang to make room for the Vintage Air A/C kit.

Jeff demonstrates how to install the front runner drive system by Vintage Air in his 1967 Chevelle project car all while maintaining a simple, factory fresh look.

Learn the installation process of a drive shaft loop kit in a 1967 Chevelle. NHRA requires a driveshaft loop if you're going to run slicks on the drag strip!

In this article, Jeff provides tips on how to successfully install a custom length driveshaft into his 1967 Chevelle. This guide explains how to take accurate measurements while choosing your specific length, slip yoke, and u-joints for a perfect fit.

Mick Rau has a garage full of cool cars, but this Hirohata-inspired Merc is a standout.

Follow along as Product Guru Jeff K. talks about customizing a Comet Pedal Car for his son!

Speedway Motors employee Jess M. talks about customizing the rear radius rods she installed on her '33 5-Window coupe.

Next up, Jeff installs a custom exhaust system in his '67 Chevelle. See how he applies tailpipe tips and incorporates exhaust cutouts during the process.

Tim demonstrates the brake assembly with a Wide 5 drum brake and Speedway's new self-energizing backing plate.

See the final steps of installing a custom exhaust system on a '67 Chevelle. Learn some tips on how to offset and install the exhaust U bend tailpipe.