1955 Studebaker E7 C6 Driveline and Axles

In this Tech Tip, John answers a customer question about finding the right axle length for his 1931 Model A.

With the coil-overs attached, it is now time to make the Chevelle rear whole again. Follow along as Jeff installs a 9" third member and spline axles with a few tips on axle lengths and bolt patterns.

Shortcuts don't always pay off. Zach Raddatz walk us through his experience with a cheap radiator so we don't make the same mistake!

This slick grey 55 Chevy truck is as clean as they come, and there are more hidden details throughout than the subtle exterior would lead you to believe.

After installing front brakes, Jeff is now ready for wheels and tires. See how a spacer is used to make his 15" wheels fit just right and a slick way to speed up the sanding and polishing process of the wheel dust caps.

Follow along as our Tech installs dropped spindels and performs a disc brake conversion on his '55 Sedan. He utilizes a metric brake conversion kit.

Learn the installation process of a drive shaft loop kit in a 1967 Chevelle. NHRA requires a driveshaft loop if you're going to run slicks on the drag strip!

Jeff preps the rear end housing to secure the brake lines and shows how to fasten bolt-on brake line tabs on the lower trailing arm bracket. Follow along as he applies Wilwood Dynalite Calipers to his 1967 Chevelle.

Derek kicks off his 55 Chevy rebuild with a fresh small block.

Learn how Zach replaces a transmission and breakaway converter in his 55 Chevy, with some helpful tips along the way.