Dynatech® 776-24352 Auger Style Muffler, 11 x 3-1/2 Inch

low cost and worked

took the bite out of the exhaust noise, small modification to make it work in a custom application

I would buy again

Worked out great for my collectors

I would buy this product again for sure

I have strait header on a blown bbc project car has no room for mufflers the auger tones the car done a bunch

yes

I put them in my 3 inch stainless tail pipes with no cat. and no muffler and they sound awesome !!

yes I would buy again over and over

just as discribed

It did make my truck quieter.

Fits great and toned my truck down. I feel like I had more power with it in.

Cut the edge off the noise

Installed in the header. Had to remove 1 fin. Db meter right at the exit is 89 now. So loud before you could not hear to talk. Patriot 26" side pipes with inserts The diameter of the auger is smaller than 3.5

Yes I would buy this again.

Welded at the end headers with turn outs sounds like a hot rod.

This thing really worked for me.

Normally I don't write reviews because I'm skeptical about them. I put a Banks Engineering 3 inch stainless cat-back exhaust system on my 2007 Nissan Frontier 4x4 few years back. Dumb move, but anyways I got a terrible resonance in the cab. Drove me nuts and I have bad hearing to boot, but still could hear it. I read about these auger type noise reducers so I bought one and installed it. Mine is in a situation where I didn't have to weld it. It when in easily. The true test was going down the highway. Oh my, what a major difference. It was very close to the OEM exhaust in noise produces. This is the best money I spend to fix my exhaust. I don't feel the restriction is going to hurt my engine any at especially with an overkill 3 inch exhaust system.

i would buy again

Perfect to take the bark out of my old aluminum Thrush side pipes' I just slipped them into some 3.5" exhaust pipe and tacked them in place. Slid the old Thrush covers and turn outs on and they look and sound great.