Triumph Stag Pipe Fitting Plugs

In preparation to transplant a 430hp 383 stroker into Project Chevelle, Zach R. made up a set of plug wires for the car. To keep it nice and tidy they needed to be routed just right, be the perfect length and not distract from the engine!

In this video, Joe and Darrian discuss and demonstrate how to properly set up and use the Speedway Tubing Notcher. It’s the perfect tool for fabricators and hobbyists alike! Use it to make headers, custom chassis, roll cages, or anything in between.

Learn about some of the differences between factory plug wires and the improvements you'll receive with a quality set of aftermarket performance wires in our spark plug wire buyer's guide

There is a lot to consider when choosing the proper spark plug for your engine's intended application and power level. Let us take some of the guesswork out with our spark plug buyer's guide.

Learn how to install spark plug wire terminal ends. Our step by step guide takes you through terminal end and boot installation with the use of a wire crimping tool.

Keep your rear cylinders running cool in a high performance engine by installing a water bypass kit to the intake manifold.

Are you a collector of automotive signs? This is a DIY project where you will learn how to convert a hardwired sign to a plug in. Jess M. explains each step to get the job done!

Dick from Koul Tools shares a tip on how to properly seat the AN fittings using the Koul Tools device.

Everyone loves boost and nitrous. But proper piston rings and end gaps are necessary to keep your engine alive. Lake Speed Jr. from Total Seal joins us to talk about the right rings for engines with nitrous and boost.

Piston rings may not be the most exciting part of an engine build, but knowing how to clock piston rings and how to install rings on a piston is critical to your engine performing properly.