Studebaker Challenger Exterior Body Moldings

Learn a few tips on how to properly mount Modified bodies and some products that will help get your race car body fabrication job done!

Learn about the power behind the G-body platform and the steps to upgrade a 7.5" bolt rear end to a 8.5" to withstand high horsepower. See how to change the differential fluid and install new gaskets.

In this budget build, a GM rear end is upgraded in order to hold 400+ HP. See how spherical bushings are replaced in a used 8.5” GM 10 bolt rear end.

Street Rod Tech Steve L. talks about the need to be able to service and adjust the shocks on your vehicle, no matter the competition you built it for.

This article demonstrates how to install a complete Winters quick change kit with additional parts including birdcages, brackets, and calipers for a modified race car.

Learn how to install an external Transmission Cooler, to help keep the temperature of your transmission consistent.

In this guide, Kevin demonstrates how to properly install an external oil cooler in his '54 Chevy Belair with a Big Block Chevy engine.

Learn how to wrap exhaust headers to help keep under hood temperatures down. This articles shows how cast iron exhaust manifolds are wrapped in 1-inch black header wrap with stainless steel exhaust wrap ties.

We all need a little help from time to time. In this case, we had a grill shell on a 1946 Chevrolet Truck that could use some stiffening. Ride along as Heath installs support rods and rod brackets.