Oldsmobile Pulley Spacers and Hardware

We’re putting Weld Racing Wheels and tires on our 410 Sprint Car and finally dropping it on the ground. Check it out!

Learn how to assemble the front axle of a sprint car. See what tools are needed for assembly including an angle finder gauge tool and king pin reamer.

Heath Petzoldt walks us through the process of putting different types of king pins together in this video. Follow along to boost your kingpin assembling confidence!

In this budget build, a GM rear end is upgraded in order to hold 400+ HP. See how spherical bushings are replaced in a used 8.5” GM 10 bolt rear end.

Preventative maintenance is crucial for hot rods. In this article, Jess shows you how to place a front wheel cylinder on an early Ford.

Check out a couple of tips on how to install a new clutch.

In this restoration project, find out how to remove rusted floor pans and install new sheet metal on a 1963 Chevy Impala. Investing in the proper tools is essential in getting the job done right!

Learn how to restore vintage 200S mag wheels. These steps ensure a smooth and successful restoration and installation.

Tim talks about the process of upgrading the factory hubs on his 1929 Roadster project with new manufacture units courtesy of Speedway Motors.

Rebuilding a carburetor or renewing it is not as hard or intimidating as it looks. This article will guide you through the steps using a Holley rebuild kit.