1987 Chevy G20 Brake Pedal

Street Rod Tech Kevin W. talks about the first steps in his plans of a disc brake upgrade on his 1954 Chevy Bel Air, upgrading the pedal to an under-dash setup and adding a booster.

Jeff converts his 1967 Chevelle manual brake system to power by installing a Delco booster kit. Learn how to make the master cylinder more resistant to brake fluid and a few tips for an easy install.

Jeff installs a Wilwood 12.19" Front Disc Brake Kit to his 1967 Chevelle. Read more on the caliper bracket assembly and brake rotor setup.

Jeff preps the rear end housing to secure the brake lines and shows how to fasten bolt-on brake line tabs on the lower trailing arm bracket. Follow along as he applies Wilwood Dynalite Calipers to his 1967 Chevelle.

Learn about the power behind the G-body platform and the steps to upgrade a 7.5" bolt rear end to a 8.5" to withstand high horsepower. See how to change the differential fluid and install new gaskets.

To keep this project moving forward, Jeff installs a gear reduction mini starter on his big block. See how to apply the mini starter on 153 or 168 tooth flexplates.

In this Tech Tip, John offers some suggestions about lowering a 1967 Chevelle.

With the coil-overs attached, it is now time to make the Chevelle rear whole again. Follow along as Jeff installs a 9" third member and spline axles with a few tips on axle lengths and bolt patterns.

A guide on how to install a floor replacement panel in the trunk of a 1967 Chevelle. Follow along to learn tips on fitting, cutting and welding sheet metal for a precise fit.

This article highlights the finishing touches of the front suspension in Jeff's Chevelle. Learn some tips on how to install the steering arms, center link and tie rod assembly.