1969 Ford E-200 Econoline Accessory Drive

Mike Earley fell in love with Chevelles when he was a little kid. Now he's lucky enough to own one of his own with a few unexpected tricks under the hood.

Jeff demonstrates how to install the front runner drive system by Vintage Air in his 1967 Chevelle project car all while maintaining a simple, factory fresh look.

When Tyson picked up his '69 SS396, all the trim was in the trunk. We follow along as he installs the shiny stuff to finish out his project.

Learn the installation process of a drive shaft loop kit in a 1967 Chevelle. NHRA requires a driveshaft loop if you're going to run slicks on the drag strip!

In this Tech Tip, a returning customer asks for advice on wiring harnesses for his ’29 Ford roadster project.

With the coil-overs attached, it is now time to make the Chevelle rear whole again. Follow along as Jeff installs a 9" third member and spline axles with a few tips on axle lengths and bolt patterns.

Follow this guide on how to install a splined sway bar for GM A-body applications. See the installation process on a '68 Chevelle frame using stock control arms and factory chassis bolt and pad locations.

See the final steps of installing a custom exhaust system on a '67 Chevelle. Learn some tips on how to offset and install the exhaust U bend tailpipe.

Jeff walks through how to install an EFI filter for his fuel system. See how to assemble conversion fittings to accurately plumb the fuel lines and tips on fuel line routing.

Next up, Jeff installs a custom exhaust system in his '67 Chevelle. See how he applies tailpipe tips and incorporates exhaust cutouts during the process.