1968 GMC C25/C2500 Pickup Accelerator Pumps

It's done! Well, at least for now. Check out the conclusion of our 1968 C10 pickup truck build!

In Episode 2 of our '68 C10 build, we rip it apart, clean up 54 years of rust and dirt, and get to work on the rear suspension.

It's alive! Our 1968 C10 truck project is one step closer to our first drive. In this episode, our old truck finally comes to life with a cammed junkyard LS.

In this Tech Tip, a customer asked for some recommendations on water pumps for his 1934 Chevy Coupe build.

We've come a long way on our '68 C10 project, but we still have a long way to go. Watch as Kevin and Joe discuss where we're at and where we're going.

Bringing an old Mopar back to life isn't always a breeze. Fortunately, MSD has come up with a solution for those outdated and unreliable points-type ignition systems. Find out how to install a MSD 8386 distributor and MSD 5531 spark plug wires

In this episode of our '68 C10 project, we hit a couple big milestones. The engine goes in and we hit our first car show. It may be just a rolling chassis, but we're mighty proud of how far we've come.

Our project '68 C10 had some pretty rough sheet metal. In this episode, we go from a scary, rusty mess to a complete cab ready for bodywork.

In this episode of our C10 build series, we swap cams in a junkyard 5.3 and make surprisingly big power.

In Episode 3 of our C10 build, we install a front suspension kit and finally have a rolling chassis!