1968 Chevy C20 Carburetor Tools

Rebuilding a carburetor or renewing it is not as hard or intimidating as it looks. This article will guide you through the steps using a Holley rebuild kit.

There's a right and wrong way to run a two-barrel carburetor on your vintage engine. Check out this guide about how to select the correct carburetor for your Flathead or vintage engine.

We've come a long way on our '68 C10 project, but we still have a long way to go. Watch as Kevin and Joe discuss where we're at and where we're going.

It's alive! Our 1968 C10 truck project is one step closer to our first drive. In this episode, our old truck finally comes to life with a cammed junkyard LS.

Our project '68 C10 had some pretty rough sheet metal. In this episode, we go from a scary, rusty mess to a complete cab ready for bodywork.

In Episode 3 of our C10 build, we install a front suspension kit and finally have a rolling chassis!

Now that our '68 C10 cab is straight and rust-free, it's time to bolt on the rest of the sheet metal, get it straight, and get it painted!

In this restoration project, find out how to remove rusted floor pans and install new sheet metal on a 1963 Chevy Impala. Investing in the proper tools is essential in getting the job done right!

In this episode of our C10 build series, we swap cams in a junkyard 5.3 and make surprisingly big power.

From a mild leveling to slammed and “in the weeds” there are several options to lowering a C10. We discuss the options in our ’67-’72 C10 lowering guide.