1967 Jeep Commando Parking Brake

Jeff preps the rear end housing to secure the brake lines and shows how to fasten bolt-on brake line tabs on the lower trailing arm bracket. Follow along as he applies Wilwood Dynalite Calipers to his 1967 Chevelle.

Step by Step instructions for the G-Comp front suspension install for a 67-69 Chevy Camaro.

Jeff installs a Wilwood 12.19" Front Disc Brake Kit to his 1967 Chevelle. Read more on the caliper bracket assembly and brake rotor setup.

See how Jeff tackles the installation of a 9" power brake booster on his '67 Chevelle. Learn some tips for this application and why it's important to leave some free travel at the top of the pedal swing.

Jeff converts his 1967 Chevelle manual brake system to power by installing a Delco booster kit. Learn how to make the master cylinder more resistant to brake fluid and a few tips for an easy install.

With the new housing and brakes installed, Jeff chooses new wheels and tires for his 1967 Chevelle. See how he gets the perfect fit with enough clearance for brakes, coilovers and even 15" wheels.

Next up is the suspension on Jeff's 1967 Chevelle project. Learn how to properly disassemble and remove components, such as the spindles and brakes. See tips on replacing the control arm bushings and using the right tools to get the job done.

After installing front brakes, Jeff is now ready for wheels and tires. See how a spacer is used to make his 15" wheels fit just right and a slick way to speed up the sanding and polishing process of the wheel dust caps.

With the coil-overs attached, it is now time to make the Chevelle rear whole again. Follow along as Jeff installs a 9" third member and spline axles with a few tips on axle lengths and bolt patterns.

In this Tech Tip, John offers some suggestions about lowering a 1967 Chevelle.