1967 Chevy G20 Van Rocker Arm Nuts

Now that the control arms have been replaced on Jeff's 1967 Chevelle, the next step is to prep the control arms for use with coil-overs. See how to apply shock absorber mounts and the steps it takes to complete this conversion.

Next up is the suspension on Jeff's 1967 Chevelle project. Learn how to properly disassemble and remove components, such as the spindles and brakes. See tips on replacing the control arm bushings and using the right tools to get the job done.

Jeff demonstrates how to install a high quality rear trailing arm kit for his 1967 Chevelle. Learn more about the a-body rear suspension and its unique set of requirements. Find out how to eliminate wheel hop and promote “forward bite”.

Jeff preps the rear end housing to secure the brake lines and shows how to fasten bolt-on brake line tabs on the lower trailing arm bracket. Follow along as he applies Wilwood Dynalite Calipers to his 1967 Chevelle.

Jeff converts his 1967 Chevelle manual brake system to power by installing a Delco booster kit. Learn how to make the master cylinder more resistant to brake fluid and a few tips for an easy install.

Jeff demonstrates how to plumb the brake master cylinder with steel lines in his 1967 Chevelle. See tips on how to bend brake lines, use flare tools to make double flares, and give hard lines some spring.

In Dave Shuten's restomod revival, a '57 Bel Air gets a new lease on life.

With the coil-overs attached, it is now time to make the Chevelle rear whole again. Follow along as Jeff installs a 9" third member and spline axles with a few tips on axle lengths and bolt patterns.

Jess M. talks a bit about the locking lug nut set from Gorilla Automotive Products that she installed on her 1933 Ford coupe to help keep her new Rocket Racing Wheels safe.

Jeff tackles the installation of the Lokar Muscle Car Shifter inside of a factory stick-shift floor pan section. This product won a "Best Interior Product" Award at the SEMA show in 2016.