Unisteer Power Rack And Pinion Kit, 60-66 Chevy C10, Disc Brakes

On this kit Unisteer used a traditional style rear steer rack And pinion that is mounted to a one piece bracket which bolts up to the outside of either frame rail in the same holes as the original steering box and idler arms.

This kit is for rear wheel drive vehicles only, NOT 4x4s. Installs have been done on V-8s, so there should be room if using a 6 Cylinder. There is quite a bit of room for the shaft support, but some headers may require modification. A two groove pulley on your water pump is required for this kit.

• 3/4" DD pinion
• 5.75" of travel
• 2-7/8" turns lock to lock
• M14 x 1.5 inner threads
• Kit Includes:
  • Rack And Pinion
  • Mounting Bracket
  • Steering Shaft Kit
  • Mounting Hardware
  • Outer Tie Rod Ends