T-Bird Offset Rack & Pinion Mount Bushings & Bolts for Spacers

Pinion Mount Bushings

We found that a lot of hot rod Mustang II cross members utilize mount spacing for Mustang II rack and pinions that mount via a center to center measurement of 16". Most aftermarket Mustang II rack and pinions are manufactured for a 15.5" center to center mount.

This bushing set allows you to install an aftermarket Mustang II style rack and pinion assembly on nearly any of the many Mustang II style cross members found in the hot rod world today.

If you are upgrading to a new power rack or even just replacing a worn out one - these bushings are a simple solution, to compliment any level of install or upgrade - saving you valuable time and money!

• Drilled, offset Delrin bushings
• Simple solution for common Mustang II suspension setups
• Hardware included
• Note one pair includes 2 ea mount bolts and 4 each bushing halves
• 1 pair will function to mount one rack/pinion assembly

NOTE: These bushings are not designed to raise or lower the rack & pinion.

 

Bolt Kit

This handy bolt kit will simplify the installation of your Mustang II or T-bird power rack & pinion using rack spacers. This kit includes 4-1/2" long bolts which are specifically for use with rack spacers such as 9101023. If your installation does not require rack spacers then you will need the shorter bolt kit 91034342-2 instead.

Kit includes:

• (2) 5/8"-11 x 4-1/2" coarse hex cap screw Grade 5
• (2) 5/8"-11 nyloc nuts
• (2) Hardened flat washers
• (1) Instruction sheet