QA1 1210-227 Hybrid K6117/K6141 Lower Ball Joint, Press-In

QA1 offers its Ultimate Ball Joint in a Press-In Style for a variety of racing applications. A 100% owner rebuildable design, the Ultimate Ball Joint is a QA1 exclusive. This ball joint is self-lubricating.

These are NOT a direct fit in the stock pickup A-frames. Used on IMCA cars to raise roll center (raised pivot point).

1. These have evolved from our three-piece spindle. The arm of our spindle goes overt he lower ball joint limiting the length of stud sticking out of the top of the boss. So instead of reaming the boss of the spindle to get the correct pin height, we found a stud that gives you the height needed, without reaming a spindle or having clearance issues.

2. Lower ball joint fits most strut cars, 1971-1976 Impala and most wide-type dirt cars.

• Housing same as 72110108 
• Stud same as 7219030
• Steel Cap
• Completely Rebuildable
• Press-In type housing