• Larger shank diameter provides additional metal to metal contact with the wheel for reduced stud flex and increases strength• Eliminates the need for aftermarket shoulder type lug nuts and simplifies wheel installation• Set comes complete with flat type lug nuts and stud spacers to fit various thicknesses of disc brake hats• 5 Per pack

Wheel studs should be installed with the tapered end of the shank towards the weel
Use thread Loctite on end that is theraded into flange
End without taper to be screwed into axle flange
Whether you use a thick or thin wheel spacer depends on the type and thickness of the disc brake that you are using.
Wheel studs have 5/8"-18 screw-in thread, are 4-13/32" overall length
11/16" diameter center shank between two 5/8"-18 threaded ends
Drag race only

Charts

Moroso 46140 Wheel Stud Instructions

CARB Warning

For race/ off road use only

Emissions warning: this part only legal for sale or use in California for racing (competition) vehicles which may never be used, registered, or licensed for use upon a public highway. Any other use renders the vehicle tampered and not legal for use on California public highways (any public street or roadway, public dirt road, public park, or publicly maintained right of way open to the use of the public for vehicular travel). Violations subject to $37,500 penalty per violation per vehicle, revocation of registration, loss of use on California public right of ways, and proof of correction for tampering. There are similar restrictions and penalties under federal law and the laws of all other states with penalties under federal law of up to approximately $45,268 per tampered vehicle and/or engine.

WARNING:

Cancer and Reproductive Harm – www.P65Warnings.ca.gov

CARB warning

Moroso 46140 Specifications

KEY SPECS
MFG. Part #	46140
Brand	Moroso
Thread Pitch	5/8"-18

GENERAL
Overall Length	4.406"
Sold in Quantity	Set

Ratings & Reviews

Be the first to write a review.

Questions & Answers

Be the first to ask a question.