Ford 9 Inch 1310-Series Short/Small Pinion Yoke, 28-Spline

Stop scrounging the junkyard for those hard to find Ford pinion yokes. Whether you’re rebuilding a stock unit for your favorite old Ford, or putting the final touches on that “bullet-proof” Ford 9-inch third member build, start fresh and save time with a new Speedway Motors Forged Short Pinion Yoke.

We replicated the original “short” 4-inch length yoke found on many late model Ford cars and trucks and updated it using modern forged carbon steel. Whether you’re restoring a vintage 1950’s-80’s Ford or Mercury to OEM specs or hooking up that ground-pounding, high-horsepower custom build – our forged pinion yoke can handle it.

This yoke will fit any Ford 9-inch with a 28-spline, 1.218” diameter pinion gear, and uses common 1310 series U-joints (91048315). Machined relief cut provides for simple, bolt-on installation when used with an OEM standard or our Daytona-style pinion support (91048399) on your Ford 9-inch third member assembly.

Step up to a modern, easy-to-install and durable solution for your Ford 9-inch rebuild by choosing a Forged Pinion Yoke from Speedway Motors. 

• Re-creation of the original Ford 9-inch “short” pinion yoke
• Made out of forged carbon steel for strength and durability
• Modern forged steel offers far more value than a junkyard yoke
• Machined relief cut to clear standard and Daytona pinion supports
• Fits all 28 spline 1.218” Ford 9-inch pinion gears
• Uses common 1310 series U-joints

This pinion yoke is an OEM replacement for the following year/make/models listed:

• 1966-86 Bronco 
• 1964-77 Comet 
• 1967-79 Cougar 
• 1968-83 E-100 1/2 ton 
• 1979-88 E-150 1/2 ton 
• 1968-74 E-200 3/4 ton 
• 1957-83 F100 
• 1968-87 F150 
• 1957-71 Fairlane 
• 1960-70 Falcon 
• 1959-74 Galaxy 
• 1975-79 Granada 
• 1975-80 Grand Marquis 
• 1965-79 LTD 
• 1968-71 Mark III 
• 1970-78 Maverick 
• 1965-73 Mustang 
• 1957-79 Ranchero 
• 1955-79 Thunderbird 
• 1968-76 Torino/ Grand Torino

• Thickness of ear where u-bolts go through is .818" or 13/16"
• Depth from face to bottom of u-joint cap recess is .520 or 1/2" plus
• Space between ears where u-joint caps fit is 3.211" or 3-3/16" plus
• Overall length is 4"
• Outside diameter at seal area is 1.813"
• Center to center of u-bolt holes is 1.415"