Dual Feed Brake Master Cylinder, 1 Inch Bore & 3/8 Forged Yoke

Dual feed master cylinder with 2 bolt flange style mount. Use with Speedway brake pedal assemblies. This cylinder is similar to those used on mid-70's Fords (Mustang, Fairlane/LTD, etc. with disc front/drum rear).

• Works well in disc/disc or disc/drum brake setups
• Mounting Bolt Holes:  3/8" or 10mm 
• 7 1/4" long without the pushrod, add 2" for the pushrod
• 3" wide from the outside of the reservoir to the edge of the outlets
• Mounting flange is 4" wide
• Master cylinder is also 3-7/16" tall without a cap
• Included push rod is threaded 3/8"-24 (fine thread)
• Speedway Motors Brake Rod Clevis
• Simple and effective piece for attaching threaded brake pedal push rods
• Pushrod boot included

Uses 3/8"-24 female inverted flare outlets. If plumbing with AN 3 lines, you will need two each of these AN to IFM Adapters.

Learn more about selecting the proper master cylinder for your vehicle by reading our tech article. Brake System Selection.