Oldsmobile Delta 88 T10 Frame

Have an extra license plate frame on hand? Here are two ways you can turn your frame into an arts and crafts project. These are the steps to create a cork board or whiteboard.

Follow along as we give our C10 truck project a much needed dose of suspension travel with a bolt-on C-notch kit.

We've come a long way on our '68 C10 project, but we still have a long way to go. Watch as Kevin and Joe discuss where we're at and where we're going.

In Episode 3 of our C10 build, we install a front suspension kit and finally have a rolling chassis!

It's alive! Our 1968 C10 truck project is one step closer to our first drive. In this episode, our old truck finally comes to life with a cammed junkyard LS.

Jason Ankerson's 1965 Chevy C10 began its life as his high school beater. Over a decade of transformations, his first-gen C10 has become a modern reliable cruiser.

In this episode of our C10 build series, we swap cams in a junkyard 5.3 and make surprisingly big power.

Now that our '68 C10 cab is straight and rust-free, it's time to bolt on the rest of the sheet metal, get it straight, and get it painted!

In this episode of our '68 C10 project, we hit a couple big milestones. The engine goes in and we hit our first car show. It may be just a rolling chassis, but we're mighty proud of how far we've come.

Heath P. tells his story on how the passion for 'hot rodding' was instilled in him by his grandfather. From driving tractors on their family farm to becoming a Ford family, you are in for a good read.