Chevy Chevelle 4L70E Shift Levers

Follow along as Jeff installs an early 700R4 transmission for the big block in his 1967 Chevelle. See how this unit is upgraded and converted to a later 30 spline style.

In this Tech Tip, John offers some suggestions about lowering a 1967 Chevelle.

Next up is the suspension on Jeff's 1967 Chevelle project. Learn how to properly disassemble and remove components, such as the spindles and brakes. See tips on replacing the control arm bushings and using the right tools to get the job done.

This article highlights the finishing touches of the front suspension in Jeff's Chevelle. Learn some tips on how to install the steering arms, center link and tie rod assembly.

Learn the installation process of a drive shaft loop kit in a 1967 Chevelle. NHRA requires a driveshaft loop if you're going to run slicks on the drag strip!

A guide on how to install a floor replacement panel in the trunk of a 1967 Chevelle. Follow along to learn tips on fitting, cutting and welding sheet metal for a precise fit.

In this article, Jeff provides tips on how to successfully install a custom length driveshaft into his 1967 Chevelle. This guide explains how to take accurate measurements while choosing your specific length, slip yoke, and u-joints for a perfect fit.

Learn about the G Force crossmember and how the symmetrical product design makes for a smooth installation on Jeff's 1967 Chevelle.