1977 Jeep CJ7 Accessory Drive

Jeff demonstrates how to install the front runner drive system by Vintage Air in his 1967 Chevelle project car all while maintaining a simple, factory fresh look.

Follow along as we install a Pete Jackson Noisy Gear Drive on a Chevy 454. Learn about the installation process from Speedway Motors Street Tech Kevin.

Learn the installation process of a drive shaft loop kit in a 1967 Chevelle. NHRA requires a driveshaft loop if you're going to run slicks on the drag strip!

In this Tech Tip, John answers a customer concerns about adding additional drop to his 1960-1972 Chevy truck.

Little is thought of your engine’s starter until it refuses to turn your engine over at the worst possible moment. Today’s powerful mini starters can crank the biggest engines with ease. Learn how in our buyer’s guide.

To keep this project moving forward, Jeff installs a gear reduction mini starter on his big block. See how to apply the mini starter on 153 or 168 tooth flexplates.

With the coil-overs attached, it is now time to make the Chevelle rear whole again. Follow along as Jeff installs a 9" third member and spline axles with a few tips on axle lengths and bolt patterns.

After installing front brakes, Jeff is now ready for wheels and tires. See how a spacer is used to make his 15" wheels fit just right and a slick way to speed up the sanding and polishing process of the wheel dust caps.

When Tyson picked up his '69 SS396, all the trim was in the trunk. We follow along as he installs the shiny stuff to finish out his project.

This article highlights the finishing touches of the front suspension in Jeff's Chevelle. Learn some tips on how to install the steering arms, center link and tie rod assembly.