1969 Chevy K20 Accelerator Pedal

Jeff demonstrates how to install the front runner drive system by Vintage Air in his 1967 Chevelle project car all while maintaining a simple, factory fresh look.

Jeff is the Speedway Motors Retail Store Manager, and his '69 Chevelle is as nice as it is fast.

When Tyson picked up his '69 SS396, all the trim was in the trunk. We follow along as he installs the shiny stuff to finish out his project.

Jeff demonstrates how to install a high quality rear trailing arm kit for his 1967 Chevelle. Learn more about the a-body rear suspension and its unique set of requirements. Find out how to eliminate wheel hop and promote “forward bite”.

In this restoration project, find out how to remove rusted floor pans and install new sheet metal on a 1963 Chevy Impala. Investing in the proper tools is essential in getting the job done right!

To keep this project moving forward, Jeff installs a gear reduction mini starter on his big block. See how to apply the mini starter on 153 or 168 tooth flexplates.

Jeff installs a Wilwood 12.19" Front Disc Brake Kit to his 1967 Chevelle. Read more on the caliper bracket assembly and brake rotor setup.

With the coil-overs attached, it is now time to make the Chevelle rear whole again. Follow along as Jeff installs a 9" third member and spline axles with a few tips on axle lengths and bolt patterns.

This article highlights the finishing touches of the front suspension in Jeff's Chevelle. Learn some tips on how to install the steering arms, center link and tie rod assembly.

A guide on how to install a floor replacement panel in the trunk of a 1967 Chevelle. Follow along to learn tips on fitting, cutting and welding sheet metal for a precise fit.