1968 Chevy G10 Van Electrical, Lighting and Wiring Parts

Check out this headlight wiring and taillight wiring diagram.

In this episode of our C10 build series, we swap cams in a junkyard 5.3 and make surprisingly big power.

This project consists of using welding cable to relocate a battery to the trunk of a 1967 Chevelle. Learn the benefits of using welding cable over normal battery cable and how line clamps are used to secure the wire to the frame rail.

It's alive! Our 1968 C10 truck project is one step closer to our first drive. In this episode, our old truck finally comes to life with a cammed junkyard LS.

It's done! Well, at least for now. Check out the conclusion of our 1968 C10 pickup truck build!

Now that our '68 C10 cab is straight and rust-free, it's time to bolt on the rest of the sheet metal, get it straight, and get it painted!

In Episode 3 of our C10 build, we install a front suspension kit and finally have a rolling chassis!

In this episode of our '68 C10 project, we hit a couple big milestones. The engine goes in and we hit our first car show. It may be just a rolling chassis, but we're mighty proud of how far we've come.

In Episode 2 of our '68 C10 build, we rip it apart, clean up 54 years of rust and dirt, and get to work on the rear suspension.

Follow this guide on how to mount a single electric puller fan in a '66 - '67 Chevelle. Learn tips on taking measurements and installing a rubber spacer to prevent the fan from rubbing.