1967 Jeep DJ5 Side Step Plates

Jeff installs a Wilwood 12.19" Front Disc Brake Kit to his 1967 Chevelle. Read more on the caliper bracket assembly and brake rotor setup.

With the coil-overs attached, it is now time to make the Chevelle rear whole again. Follow along as Jeff installs a 9" third member and spline axles with a few tips on axle lengths and bolt patterns.

Jeff's 1967 Chevelle project undergoes prep for a Dakota Digital Dash System. Keep a factory style dash with this wide sweep speedometer. Learn how to mount and wire modules for the gauge system, gear shift indicator, GPS speedo sender and auxiliary.

With the new housing and brakes installed, Jeff chooses new wheels and tires for his 1967 Chevelle. See how he gets the perfect fit with enough clearance for brakes, coilovers and even 15" wheels.

This article highlights the finishing touches of the front suspension in Jeff's Chevelle. Learn some tips on how to install the steering arms, center link and tie rod assembly.

In this Tech Tip, John offers some suggestions about lowering a 1967 Chevelle.

Learn about the G Force crossmember and how the symmetrical product design makes for a smooth installation on Jeff's 1967 Chevelle.

A guide on how to install a floor replacement panel in the trunk of a 1967 Chevelle. Follow along to learn tips on fitting, cutting and welding sheet metal for a precise fit.

Jeff preps the rear end housing to secure the brake lines and shows how to fasten bolt-on brake line tabs on the lower trailing arm bracket. Follow along as he applies Wilwood Dynalite Calipers to his 1967 Chevelle.

Jeff demonstrates how to plumb the brake master cylinder with steel lines in his 1967 Chevelle. See tips on how to bend brake lines, use flare tools to make double flares, and give hard lines some spring.