1966 Chevy C20 Intellitronix Create-A-Dash Kits Parts

Jeff's Chevelle gets a dash overhaul. Follow along as he assembles the dash components and installs the A/C evaporator unit. This project highlights a refinished dash top, Astro vents and a new padded dash bumper.

This Dakota Digital Instrument Cluster, modeled after a factory SS dash, is a must for your Classic car or Muscle car. Check out this article to learn about the unique features and how it requires only one cable to plug in for install!

Jeff's 1967 Chevelle project undergoes prep for a Dakota Digital Dash System. Keep a factory style dash with this wide sweep speedometer. Learn how to mount and wire modules for the gauge system, gear shift indicator, GPS speedo sender and auxiliary.

Learn how to assemble a Gotta Show transmission cooler line kit for common GM transmissions. Jeff shares some helpful tips on measuring and cutting the braided stainless steel hose for an easier installation.

Jeff demonstrates how to install the front runner drive system by Vintage Air in his 1967 Chevelle project car all while maintaining a simple, factory fresh look.

Zach R. walk through how he selected the perfect Tach for his ride.

Learn the installation process of a drive shaft loop kit in a 1967 Chevelle. NHRA requires a driveshaft loop if you're going to run slicks on the drag strip!

This article highlights the finishing touches of the front suspension in Jeff's Chevelle. Learn some tips on how to install the steering arms, center link and tie rod assembly.

In this article, Jeff provides tips on how to successfully install a custom length driveshaft into his 1967 Chevelle. This guide explains how to take accurate measurements while choosing your specific length, slip yoke, and u-joints for a perfect fit.

With the coil-overs attached, it is now time to make the Chevelle rear whole again. Follow along as Jeff installs a 9" third member and spline axles with a few tips on axle lengths and bolt patterns.