1956 Studebaker E7 Trailing Arm Brackets

Jeff demonstrates how to install a high quality rear trailing arm kit for his 1967 Chevelle. Learn more about the a-body rear suspension and its unique set of requirements. Find out how to eliminate wheel hop and promote “forward bite”.

Speedway Motors employee Steve upgraded the trailing arms on his 1976 Chevrolet Laguna with some spherical bushings.

Jeff preps the rear end housing to secure the brake lines and shows how to fasten bolt-on brake line tabs on the lower trailing arm bracket. Follow along as he applies Wilwood Dynalite Calipers to his 1967 Chevelle.

Learn how replace lower and upper rear control arms. Read up on racer Steve's A-body control arm replacement and the bushings included kit he recommends.

Kevin W. walks through each step of installing a new alternator bracket on a 454 Big Block Chevy.

This is the amazing story of a 1957 Corvette that was built by GM as a factory-backed race car and test mule for the experimental Rochester Ramjet fuel injection. It won its class at Nassau and Daytona, then disappeared into a Chicago garage for 47 years.

Looking for a cost effective way to upgrade the front of your car? This article shows the steps to replace upper and lower stock control arms with tubular control arms for added suspension strength.

Next up is the suspension on Jeff's 1967 Chevelle project. Learn how to properly disassemble and remove components, such as the spindles and brakes. See tips on replacing the control arm bushings and using the right tools to get the job done.

In this Tech Tip, John responds to a customer request for our recommendations on brake kits for his ’56 F100.

Jeff demonstrates how to plumb the brake master cylinder with steel lines in his 1967 Chevelle. See tips on how to bend brake lines, use flare tools to make double flares, and give hard lines some spring.