UniSteer 8010540-01 1967-74 GM Power Rack & Pinion Kit

This rack & pinion conversion kit from Unisteer will give your Nova the ease of steering and road feel modern cars have. Each kit is engineered to bolt in without sacrificing steering geometry or safety.

The mounting bracket attaches to the bottom two control arm bolts on the rear of the crossmember. To install, simply remove the existing bolts and replace with the provided longer bolts, bolting the rack up into position. Then unbolt the stock steering arms and replace them with the new steering arms provided and attach the provided outer tie-rod ends, and that is it.

• Matches stock steering geometry - little to no bump steer
• Complete bolt on kit - no welding or chassis modification required
• Works with both big block and small block engines
• Kit comes standard in black powder coat
• Works with factory steering pump (new lines required, see Notes)

Power racks use the 17mm DD spline. Will work with both B/B and S/B engines.

Fits

• 1967-69 Camaro
• 1968-74 Nova X-Body

Instructions (PDF)

• Kit Includes
  • Power rack and pinion attached to the mounting bracket
  • Mounting hardware
  • New steering arms and outer tie-rod ends
  • AN 6 banjo fittings for the rack
  • Installation instruction manual
• Includes banjo fitting kit to AN6 but does not include the lines
• Banjo fittings included are unique to the rack and must be used for AN# 6 inlet/outlet hose connections
• Rack Specs
  • Length: 44"
  • Turns Lock-to-Lock: 2.5
  • Travel: 5"
  • Thread: 14mm x 1.5
  • Spline: 17mm-DD