UniSteer 8012380-01 Rack and Pinion, Power, 1973-87 Chevy C10

Rack and Pinion - Power - 1973-87 Chevy C10

• On this kit we used a traditional style rear steer rack & pinion that is mounted to a one piece bracket which bolts up to the outside of either frame rail in the same holes as the original steering box and idler arms.
• This kit is for rear wheel drive vehicles only
• NOT 4x4s. Installs have been done on V-8s
• so there should be room if using a 6 Cylinder.
• There is quite a bit of room for the shaft support
• but some headers may require modification.
• A two groove pulley on your water pump is required for this kit.

Put some cool in your C-10 with one of Unisteer’s Rack and Pinion kits. Each kit is designed to be 100% bolt in. Cruise the boulevard in style and enjoy the feel!