UniSteer 8011740-01 Rack and Pinion

Rack and Pinion - Power - 1960-66 Chevy C10 - w/Drum Brakes

• On this kit we used a traditional style rear steer rack & pinion that is mounted to a one piece bracket which bolts up to the outside of either frame rail in the same holes as the original steering box and idler arms.
• This kit is for rear wheel drive vehicles only
• NOT 4x4s. Installs have been done on V-8s
• so there should be room if using a 6 Cylinder.
• There is quite a bit of room for the shaft support
• but some headers may require modification.
• A two groove pulley on your water pump is required for this kit.
• Note: If using disk brake spindles order kit 8011920-01.

Make your classic truck steer and handle like your daily driver!