UniSteer 8011530 Rack and Pinion, Power, 1958-62 Corvette

Rack and Pinion - Power - 1958-62 Corvette

• This kit that starts with a rear steer center take off style rack & pinion made to match the stock suspension of these Corvettes.
• The rack is mounted to a one piece bracket that mounts to the stock motor mounts.
• The kit does clear the z-bar and 4 speed linkage. This kit works on Small Block motor cars with stock manifolds or Shorty headers. Other headers may work with modification.
• Everything that you need is included minus the Ididit column. The shaft kits use three u-joints and a support bearing.
• This connects up with a new Ididit retrofit column. You must use the column to use this kit! Floor Bracket and Gasket are included.
• A pump kit with bracket to mount to the block is included which comes with a remote reservoir
• single V-groove pulley and lines.
• Note: An Ididit retrofit Column is needed for this kit to work. Unisteer does not Supply Ididit Column.

Time your classic Vette gets a makeover with Unisteer’s bolt in kit! Precise rack & pinion steering in your classic Vette!