UniSteer 8011090-01 Rack and Pinion

Rack and Pinion - Power - 1975-81 Camaro - 396-454 - Long Water Pump

• This kit is extremely similar to our '70-'74 Camaro kits. The main difference is the column
• so we have a different shaft kit.
• This uses a front steer center take off style rack & pinion attached to a one piece mounting bracket which bolts to the same mounting holes for the original steering box and idler arm.
• The center steer rack & pinion replicates the original steering linkage.
• These kits have been used on both small block and big block motor cars. A 3 u-joint shaft kit and support bearing is required with either the small block or the big block.
• Clearance around headers is always an issue. Installs on cars with big blocks have been successful with either the stock manifolds or Headman Hustler 2 1/8" Headers.
• Note: On some aftermarket engine blocks
• the deck height may be raise by up to 0.4". This may affect your exhaust header location.
• Note: Some aftermarket cylinder heads may have a raised exhaust floor
• anywhere from 0.25" - 0.4" which may also affect your header location.
• Our kit is set up for use with either small blocks or big blocks using long water pumps.
• If you have a short water pump or are using an LT or LS engine
• we can set you up with the different accessories that you will need
• but you need to give us a call to arrange a kit.
• P-pumps are also popular with these Camaros
• if you would prefer a P-pump we can set you up with a P-pump tested and set to run with our rack or a power steering box if you have that. Black & Chrome finishes are available.

Tough to go for a “Joy Ride” when your Camaro is wandering all over the road! Make that ride a “True Joy” with one of our bolt in Rack & Pinion Steering Kits! Make your friends shiver with envy.